Local Network Address Change

[RonMorrill]

I have a WRV210 router. I can see it and configure it either manually or through the setup program. If I change the router address from 192.168.0.1 to 192.168.3.1 and reboot both the router and my computer I can access the internet, ipconfig says that 192.168.3.1 is my gateway, but I cannot log on to the router at 192.168.3.1. The MS PD tool says that the connection was rejected by the target. Reset router more than once with the same result.

[Rajdeep Parmar]

Hi...

nothing u have to add that ip renge in your network.

how ????

open local area network -- properites - - TCP /IP -- Select properties again ..

it will open a new window.. where  u can config ur ip address manually & DCHP ...

select use the following ip add . 192.168.3.4  255.255.255.0 ( ur subnet mas k)  192.168.3.1 ( GW ) 192.168.3.1 ( DNS)

then  bottom of the page u can see one advance button click on that one  put any ip addres of that range .. like ..192.168.3 .240

save it n reboot ur router ...

n now try to open in web page....

Thnks,

Rajdeep P .