- The Lynksys commercial area says that the router works with Frame Relay.In the configuration options there PPPT the protocol, but the protocol that my ISP sent me is PPP.Which protocol I have to configure?
OBS.: The next piece of data sent by the ISP: Commercial: Protocol MLPPP / Routing / Static Routing Balancing NO / Address Block (LAN) 192.168.4.0 / Address Mask 255.255.255.0 / Topology Full MeshedQoS NO
The RV has nothing to do with routing down a FR, it's just a device at the network edge.
There is no way, that i can think of to specify a DLCI that is part of the routing to a next hop .
It's a router that can sit of a Frame relay and route to different gateway addresses, but the Integrated access device that it would route through to different FR nodes has to take care of the routing over the DLCI's.
The RV0XX has no understanding of FR LMI, DLC, it's just a low cost edge router.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...