I have a SRP547W when I connect the Verizon UML290 the Mobile Network screen show Card Status “Error”
I have confirmed the 4g card works from the laptop in the same area of the office as the router. The card is shown on the compatibility chart to work with the router running firmware 1.2.4 which I am running.
I have the multi-wan config screen set to connection failover enabled and the wan interface priority with EthernetWan2 priority 1 and USB3G as priority 2
My goal is to have the USB 4G as the main internet connection since it is faster then the other services I can get from the building owners. If anyone has a working config example of an UML290 on a SRP547 I would like the help
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...