I'm having problems connecting my WRP400 router using as a mobile network a USB Huawei E156B card.
Strange thing is that it was working fine on Mexico City, but when I sent to Morelia it is not connecting anymore. If I reload the router it says it has signal and detect the card fine, but when I click the connect button, send the connecting message, then an error and at the end I can't see the USB card anymore. I need to reload the router in order to see it again.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...