As the title states I'm migrating to a RV320 from a RV042. I'd like to minimize the downtime of the network and need to configure the RV320. Is there a way to view the backup Mirror.config file from the RV042 and be able to create a startup.config file that I could load into the RV320?
unfortunately we cannot upload config file from RV042 to a RV320, because they are different platform, so in this case we need to configure the RV320 on lab environment and after that moving to the productive network to minimize the downtown of the network
What I'm trying to do is put all the settings from the old router into the new one, I'm sure everyone gets that. What I'm trying not to do is something like using a paper and pencil, navigating page by page writing all the settings down.
Are there any tools, methods, workarounds that would allow a tech the access and ability to read or modify the .config files?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...