Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiple private networks and One-to-One NAT on a Linksys RV016

Hello folks,

Do you know by any chance if it is possible to set up One-to-One Nat rules in order to map multiple private networks with public IP addresses on a Linksys RV016?

 

We bought a couple Cisco Small Business SG500 switches and we have set up 3 VLANS (192.168.168.1, 192.168.2.1 and 192.168.6.1). However, I only get the option configure nat for 192.168.168.0 since it is the default network on the Linksys router and default vlan on the switch. Is there a way to add more subnets to the NAT rules on this router? Same goes for port forwarding.

 

 

 

 

 

Thanks in advance!

75
Views
0
Helpful
0
Replies