The instruction manual says you can add subnets to the Router on page 29, but it is not very clear about doing so. When you had a second subnet what IP does the router have? Is there a gateway on the 2nd subnet or is the gateway the original IP of the router? I have been trying to keep the wired and the wireless traffic apart on the router and have been using vlans but I have just added another wap and it is not getting out thru the gateway to the internet.
Hi Avander, when enabling multiple subnet you will type in the IP address and a subnet mask. So if you type in 192.168.2.1 with 255.255.255.0 mask, then 192.168.2.1 becomes the default gateway for that subnet. The router will still maintain its original IP address. So if you're managing the router through 192.168.1.1 that will remain the router's IP address.
Please mark answered for helpful posts
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...