My router Linksys RV016 does not upgrade the Firware from 2.0.10 to the latest 3.0.19
I need to upgrade the Firmware from a 2.10 version to the latest version (3.0.19). I traied three times to upgrade (flash) an what occure is the same. I will explane: Ones insight the Router RV016, via internet, and in the System Manager > Firmware Upgrade, I browsed the upgrade wich name is RV016_v22.214.171.124tm_090216_code.rmt, then click on the boton for upgrading and the Loading action takes place for undefine time (ones I let it loading for more than 12 hours).
What happen? I notice that in the System Summary menu the System up time actualice without the correct time zone [I change to the correct one, no problem] but it does not upgrade the Firmware version. What can I do to do so?
Re: My router Linksys RV016 does not upgrade the Firware from 2.
I had the same problem on my RV016. I originally had version 1.2.3 and tried upgrading to version 3.0.19 and kept receiving the bad upgrade image message (if that is what you are getting). I had to go to version 2.0.0 then 2.0.3 then to version 3.0.19. Although this was done succesfully, I am getting packet loss from this router so I am going to purchase another product. Seems to be a hardware issue at this point.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...