Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need help. How do I config an RV082 for Dual Wan & VOIP

We have a RV082 configured with two ISP Wan connections. We recently implemented a VOIP phone system (SIP) (192.168.1.50) that is being used in appliance mode on our network. We currently have two WAN connections Load Balanced. My goal is to configure all my VOIP traffic to go out through the 1st ISP and the rest of the data through ISP #2. is this possible to achieve using the RV082? We are using a Skype SIP Trunk connection.

any help would be appreciated

1 REPLY
Silver

Need help. How do I config an RV082 for Dual Wan & VOIP

Yes, its possible since you are using both Wan's.Look under system management where you select dual wan/load balancing mode at the bottom there is a section called protocol binding. This section will allow you to bind certain protocol lets say VOIP out one Wan and DATA out the other as you specify it. The admin guide should have a section on protocol binding.

hope this helps,

   Jasbryan

512
Views
0
Helpful
1
Replies
CreatePlease login to create content