Hello, Ive been trying to setup a vpn with a RV120W, but i havent been able to make it work.
I am able to browse and ping local IPs in the remote network but I cannot redirect all traffic trough the vpn. Once im connected to the vpn I'm not able to visit any other external website. All I get is "Page cannot be displayed", even trying to ping external IPs just gives me time-out.
Could you please point me to the right documents or help me with the configuration?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...