Recently i bought RV042 for speed up my Internet connection. I have two ADSL Internet connection both have 1.5 mbps bandwidth speed and both have dynamic ip address. I want to setup connection in windows 2003 server, in server there is two network interface one is for LAN and second one is empty so i want to use this for RV042, this server act in my LAN as Microsoft exchange, proxy and DHCP.I try to connect this router to this server but server not get the ip address from RV042 and not able to access the router but when i connect it to my laptop it get the ip address and i am able to access the router, i am layman and need step by step help.
For better understanding my words i am attaching my network topology drawing and sorry for my poor english
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...