In order to be able to configure AVC you first need to go to the Tab of Security->Application Control and activate the feature, in this case because you are still under the evaluation mode is going to allow you to activate the feature, then enter the configuration desire and you can move on with the config of the AVC.
Thanks I created a test policy with no setting. It seems to be working. I am seeing an issue in application control statistics. I have a SG300-28 layer 3 switch in layer 3 mode feeding the RV340 router in a router VLAN using a 30 bit mask. The problem I am seeing is all the traffic out going is reported as coming from the layer 3 switch not the individual devices. So upload is not usable. Download works because it has the individual IP addresses which allows me to distinguish between devices by IP. Is there a way to fix the upload to show the individual devices and not the layer 3 switch?
Web Interface Not Responding After Firmware Upgrade to Version 1.0.01.18 on RV34x Series Router
The RV34x series router web interface may not respond after upgrading the firmware to version 1.0.01.18 from 126.96.36.199. This docum...
Configure Port Forwarding/Port Triggering/NAT on RV34x Series Routers
Explain the purpose of port forwarding and port triggering and provide instructions to set up these features on your RV34x Series router.
Configure SLAAC Settings on the RV34x Router
A Wide Area Network (WAN) is a network that covers a broad area. A user or network of users can connect to the Internet through an Internet Service Provider (ISP) who offers v...