I am working with Site to Site Vpn connection. I have four site to site vpn tunnel on my cisco RV130W. Now my question is how to confirm that each traffic from my local lan will only use its vpn tunnel from 4 site to site ipsec vpn tunnel. how to configure this.
Remember that is depending of the LAN on the other site, for example if a computer on your local LAN is 192.168.1.20 and this computer is trying to reach a computer with the IP address of 192.168.20.2 the router automatically is going to send the request to the correct tunnel, that is the reason why when you configure the site to site VPN you are request to enter the LAN of the remote site.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...