cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1145
Views
0
Helpful
1
Replies

point to multipoint Ipsec VPN Tunnel

shamimoz777
Level 1
Level 1

I am working with Site to Site Vpn connection. I have four site to site vpn tunnel on my cisco RV130W. Now my question is how to confirm that each traffic from my local lan will only use its vpn tunnel from 4 site to site ipsec vpn tunnel. how to configure this.

1 Reply 1

wycalero
Cisco Employee
Cisco Employee

Good Afternoon,

Remember that is depending of the LAN on the other site, for example if a computer on your local LAN is 192.168.1.20 and this computer is trying to reach a computer with the IP address of 192.168.20.2 the router automatically is going to send the request to the correct tunnel, that is the reason why when you configure the site to site VPN you are request to enter the LAN of the remote site.

Regards.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: