I have a Cisco RV220W that I am trying to set up to view the store security cameras remotely. I can view the cameras when connected to the LAN but not with a WAN connection. The Video recorder is an ADT system.
The port is the viewing port for the DVR. Any help would be appreciated. Thanks
I have looked into the RTSP standard, and it looks like the default ports are 554 for TCP and UDP. Since it looks like your cameras are using a different port, you may want to try creating a custom service for 8016 externally, since the default rule is currently translating 554 to 8016. Of course you can also try connecting to the cameras with the public IP and port number 554, that should work with your current setup.
However if you are unable to change the port your client software uses, definitely try creating a custom service for 8016. You may also want to double check that the camera has the RV set as it's default gateway.
Hope that helps,
Christopher Ebert - Advanced Network Support Engineer
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...