Trying to setup a port forwarding. I am in the Firewall tab and setup services for TCP and UDP port 7195. I then went to IPv4 rules and setup a rule that from Zone insecure(dedicated WAN) to Zone: Secure (LAN) with service name (that was created in services) action always allow Source host: ANY
Source Nat: default Destination NAT internal ip which is our server ip, Enable port forward checked with port 7195.External IP: Dedicated WAN
I setup both my TCP and UDP rules made sure to enable and still is not working. When go to our webpage and click on the link, just give connection failure message. Can some please tell me if I am in the wrong place for port forwarding. The unit is a Small Business Pro Security Appliance Product ID: SA520-K9 Version V01
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...