Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Privilege Level Authorization Access

Can anyone tell me how to authorize show run command to privilege level less than 15?

I have tried to authorize the show run command to privilege level 3 but it is not showing the complete configuration. It is just showing the configuration size and when last configuration was changed.

 

Regards,
Mukesh Kumar
Network Engineer
Spooster IT Services

 

5 REPLIES
Bronze

Expected behavior, please

Expected behavior, please refer to the following link

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml

for more info.

regards

Moorthy

 

New Member

Hello MoorthyThanks for your

Hello Moorthy

Thanks for your response.

The command that you have told does not show the full running configuration. I have found some commands to see the full running configuration. Here are the following command that we have to configure on the device:

(config)# privilege exec all level 3 show running-config

To see the full running configuration we have to use the following command:

# show running-config view full
 
But these commands are not supported on Version 12.2(25r)SEE4. 
Is there any other method to see the complete running configuration?
 
 
Regards,
Mukesh Kumar
Network Engineer
Spooster IT Services
 
New Member

Hello Moorthy,Does Parser

Hello Moorthy,

Does Parser View feature available in 12.2(25r)SEE4 IOS version?

I want to give privilege level 3 to a user and he can run the command "show run".

 

Regards,
Mukesh Kumar
Network Engineer
Spooster IT Services
 

Bronze

Use this below examples :

Use this below examples :(shown for some of the commands)

privilege exec level 3 traceroute
privilege exec level 3 ping
privilege exec level 3 show ip
privilege exec level 3 show startup-config
privilege exec level 3 show running-config
privilege exec level 3 show configuration
privilege exec level 3 show
privilege exec level 3 clear counters
privilege exec level 3 clear

New Member

Hello MoorthyAfter running

Hello Moorthy

After running these commands still i am not able to see the full running configuration.

It shows the following output when i run "show running-config" command.

Output:

R1#show run
Building configuration...
 
Current configuration : 53 bytes
!
boot-start-marker
boot-end-marker
!
!
!
!
end
 
Is there any method to give access of "show run" command to the user of privilege level 3?
 
 
Regards,
Mukesh Kumar
Network Engineer
Spooster IT Services
 
 
126
Views
0
Helpful
5
Replies
CreatePlease login to create content