I've configured a VPN connection between the SRP and pfsense but the connection doesn't get establised because phase1 timeout. according to racoon the Remote Side not responding.
Before this, I've correctly established a VPN between this SRP and another pfsense box, but with a public IP address. From the same host I've another vpn to the pfsense box (172.16.16.1) correctly working.
These the settings on the SRP:
Exchange mode: aggressive
Enabled ID: Manual
Remote ID: 172.16.16.2
DH Group: Group 2
Policy Type: auto policy
Remote endpoint: IP ADDRESS
SA Lifetime: 7800
Local and remote subnet setting according to the network setup above (192.168.x.x).
How can I check what's wrong? I struggled for several hours now and haven't managed to get out yet! Any help really welcome!
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...