I seen in the attachment that your using dyndns on your router. And that your getting your wan ip address dynamically. Is your wan ip address changing when the tunnel disconnects or is it staying the same. The reason i am asking is if it is changing the tunnel will go down independently and the internet will stay up. Since there is no static ip address to maintain the connection your at the mercy of the address not changing.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...