I have problem with quality of VOIP call with Linskys RV082. Firmware is 126.96.36.199tm.
Router is configured as dual-wan , one port (WAN2) is for ADSL 8000/512kb and other one is (WAN1) SHDSL 8000/8000kb.
VOIP traffic from certain IP of LAN is routed to WAN2 (through protocol binding). We have quaranted QOS on ADSL by ISP.
Problem is that voice is dropping when we load WAN2 with other data connection. Last week i reload new firmware, restore default factory and configured router whole again. All was ok only for 1 day and then voice was dropping again. I mean that problem is at mark packets, because when I put VOIP PBX in front of behind router , QOS is working fine.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...