I have two RV016 that works very well with a VPN . Two both routers have two WAN connections (each one). The problem is when WAN1 fails (because the Internet fails) tunnel goes down, and the only way to fix this is if I change the WAN1 cable by the WAN2. I know that RV082 has Tunnel Backup, but RV016 doesn´t. What is the best way to make work two WANs with one Tunnel?
Another option might be to use the SA520 (wait for next firmware release) or use the SR520 series, 800 series, or 1811 Cisco routers. This will require some CLI to implement, and you can use the CCP gui for most.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...