Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS binding limited to IP address range and SSID on WLAN

Our VLAN id 2 is used only by a WLAN SSID

Defining a QoS profile as using VLAN id 2 did not work. No upper rate limitation worked

Only using the IP address range of the VLAN or the SSID appeared to work.

It does not appear consistent, when a VLAN id can be specified on a WLAN in the  Wireless Basic Setting Table

It is also inconsistent, that the proper SSIDs are not listed in the drop down box on the

Add / Edit Profile Binding Configuration page. They only appear as AP-1, AP-2 etc.

Everyone's tags (5)
2 REPLIES
New Member

QoS binding limited to IP address range and SSID on WLAN

This is on the RV220W using firmware 1.0.3.5

New Member

QoS binding limited to IP address range and SSID on WLAN

Has this been fixed under firmware 1.0.4.17? I cannot get this work with any type of Traffic Selector (IP/MAC/VLAN/DSCP/SSID).

Any suggestions are greatly appreciated. Thanks!

845
Views
0
Helpful
2
Replies
CreatePlease login to create content