hello everyone, im a newbie regarding the networking world.
just want to ask regarding the wrt120N Router, it is capable for E1 line? i mean i have my remote substation connected to the central office thru e1 line. im planning to deploy IP camera for the remote substation the i want to monitor it to Central office. Is the wrt120N capable of converting the e1 line to ethernet?
need your help in line with this matter, or if you have good advice please reply with this post...
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...