Question using RV082 WAN Router with Cisco VPN software
I work at my home and connect to my employer's internal network via en employer supplied Cisco VPN Client Version 4.8.02.0010 (see below).
I am considering replacing by Linksys BEFSR81 router with a Cisco RV082 WAN Router. I am trying to confirm that this version of the VPN Client is compatible with the RV082. Any help would be appreciated.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...