Redirect internal requests to the WAN IP of a natted solution
I was curious if there was a way to redirect internal requests to the WAN ip of a natted sloution back to an internal IP.
Currently we have a BZN service with a single WAN, natted private LAN. Customer ha several port forwarding rules in place for external requests to their servers. The customer would also like the employees to use the public WAN IP for accessing these internal devices so when they are out of office, their apps still work.
I would assume a simple firewall command for any out requests to the IP should be directed internally, just not sure of the prpoer CLI command strings to accomplish the requirement
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...