I have spent hours trying to get the wireless network that is built into the Netcomm NB9W ADSL router to communicate with the RVS4000 VPN router that I have recently purchased.
Everything else is fine, I can connect the ADSL through to the RVS4000, it is just that I can't seem to find the correct settings to route the wireless traffic to the rest of our LAN.
The Netcomm NB9W is set to use the range 192.168.0.1 - 192.168.0.255. The RVS4000 is connected to the ADSL gateway via a static IP of 192.168.0.3
The RVS4000 is set to use the range 192.168.1.1-192.168.1.255. Our main file server is located at 192.168.1.70
I have tried many combinations of static routes, turning on dynamic routes etc so that the PCs connecting via the DHCP server on the Wireless network (192.168.0.75 - 99) to communicate with the rest of the network and in particular with the file server at 192.168.1.70.
I would be very grateful if someone could set me straight on the settings that I should have in place for the RVS4000 VPN and if possible the Netcomm NB9W.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...