I need some help deciphering these firewall settings - see attached
Settings 1 and 2 deny all traffic from specific IP Addresses.
Setting 3 allows traffic from WAN1 to a specific address.
Settings 4-7 are all deactivated.
The final 3 settings are all default settings. It appears from these that all traffic from WAN1 and WAN2 is denied. This is where I'm confused. If the traffic is denied then how is traffic getting to my server from the outside? Am I not understanding these settings correctly?
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...