I have a Cisco RV180 small business router. I am trying to make a set of outbound rules to block SMTP traffic on all devices except the Exchange mail server located at 192.168.16.3
I have attached pictures of the two rules.
Outbound rule #1 has priority of '1' and ALLOWS SMTP traffic from 192.168.16.3 (source) > ANY (destination)
Outbound rule#2 has priority of '2' and BLOCKS SMTP traffic from ANY (source) > ANY (destination)
With these two rules enabled, e-mail stops flowing. If I delete rule #2 the e-mail flows. Have I configured the priority correctly? I go to ACCESS RULES, Reorder, connection type 'outbound' and I move rule #1 to priority 1.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...