I just bought a RV 120W router and 2 WAP200 access points. What I'm trying to do is setup a guest network at my restaraunt along with a private network for us to use. I can setup 2 VLAN's on the router, and the same 2 VLAN's on my WAP200's. I can access both wireless networks from the WAP200's and get my address from each one. My networks are:
VLAN1: 10.10.1.0/24 (private)
VLAN2: 192.168.1.0/24 (guest)
My issue is that when I'm on the guest network I am still able to see my shares on the private network. I have enabled isolation between SSID on the WAP200's and isolation within SSID also. I need to make it if on the guest you can't access anything on the private network for PCI compliance with credit cards and other information going over the network. My network setup is this:
RV120W->Dlink PoE Switch->WAP200's
I have also tried setting up as: RV120W->WAP200's but get the same result.
Any suggestions on what to try? I have made sure that inter-vlan is enabled on the RV120W also.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...