I have a switch that I have configured with a voice vlan. I would like to use WAN 1 as the primary for voice and have other network traffic use WAN 2 for its primary and have both sets of traffic failover if either connection goes down. It this even possible with these two routers. It seems from the documentation that I can do one or the other but not both...
when load balancing and a wan fails its traffic will go across the only available wan left. so you can set up policy based routing to wan 1 for a specific protocol, and when that wan fails its traffic will flow through wan 2.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...