I have an RV016 and I have setup rules to block all traffic from any source to any destination. The ports I am trying to block at TCP and UDP port 1000 to 65535.
Sometimes it works and blocks and other times it doesn't. I am really trying to stop encrypted torrent traffic and I know that this is not really the answer so I do have a traffic prioritizing box as well but thought that this might help too.
I have 4 high speed connections and about 60 users. It is a mining camps open network so I cannot control what the clients are doing.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...