Hello. I have been using RV0's for quite a few years now, one thing that has bothered me is I have never been able to find or see any logging of actual users utilizing pptp vpn tunnels and when they initiate and close their tunnel connections. I am unable to see this information via the rvo gui log as well as in my syslog it dumps out to. Does the rv0 simply not provide this logging? If so why not? It seems like such a basic feature I am surprised if it is incapabile or unsupported. Thank you.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...