The RV016 is currently configured to send email alerts when the log reaches 50 events. These emails are currently failing with "authentication required" errors. There's nowhere to specify credentials, so I'm not sure how or why this is happening. Additionally, the address included in the configuration is currently working for a different reporting application on the network, so I know it's valid and routing correctly.
Suggestions for next steps? I've disabled the email alerts because I think they're locking up the router, but I want to get this working.
This happens whether I specify a specific port (INSERTMYHOSTNAMEHERE.COM:25) where "insert..etc.etc." includes my actual server address - which works for the other applications that are emailing through the router.
So, the problem to me appears to be that (a) the hostname is wrong, which I know isn't true, (b) the port is wrong, but that's the port that works for the other correctly functioning emails, or (c) some additional credentials are required, but there's nowhere to enter that information.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...