Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RV016 redirect one specific secured website to WAN

Hi,

We have one secure website which uses http Protocoll. The website has an IP address security, once the ip addresses changes, the session timeouts and you will need to login again. It is nearly impossible to login.

I have used the Protocol Binding as follows:

Service: http

Source IP: 192.168.100.1 to 192.168.100.254

Destination IP: 80.80.228.10 to 80.80.228.10     (IP of the website)

Interface: WAN2

The above configuration fails, but if I insert in the destination ip 0.0.0.0 to 255.255.255.0 it works.

Any idea how can I divert the http traffic only for the specific website to one wan?

Regards,

Stephane

2 REPLIES
Green

RV016 redirect one specific secured website to WAN

Hi Stephane, I am suspecting since you say "secure" you're missing a second bind for https.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

RV016 redirect one specific secured website to WAN

Hi Tom,

thanks for your reply. No, this site is no https. I have already another binding rule for https which works fine.

As already said, if I set the destination ip to any it works. Setting only to the websites ip not.

I made also a ping test to the website from the RV016 and it confirms the websites IP.

Regards,

Stephane

260
Views
0
Helpful
2
Replies
CreatePlease to create content