I have an RV016 small business router and out of no where, some of the ports switched from link status up to link status down. All the ports that say link status down obviously don't work now, but I can't figure out why this happened or how to fix this issue. I tried resetting my router but that didn't work, I tried using a different cable, but that didn't work. All these ports also went from full duplex to half duplex, and even when i change the management of the port to manual and make the port full duplex, it will not change it in the status menu. Any Suggestions?
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...