Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RV016 Small Business Router Does not Answer to Incoming Ping

Hi, please assist on the Cisco RV016 Small Business Router (firmware version 4.0.4.02-tm) . We have several old RV series Linksys, and the interface seem identical to this new Cisco version so it isnt difficult to have it configured. However, I am facing issues. I cannot ping from untrust to WAN IP of the router.  However pinging from trust to any IP is just fine.

I tried disabling firewall, I also created a firewall rule that allows all ICMP from ANY to ANY. I also tried All traffic from Any to Any. But still the WAN1 and WAN2 IP addresses (Multiple ISP) still does not reply to ICMP. Is this a known issue or are there any setting need to be done? Thank you.

Everyone's tags (1)
3 REPLIES
Bronze

RV016 Small Business Router Does not Answer to Incoming Ping

Hello Hector,

Under the Firewall setting, there is an option to 'Block WAN request' Make sure that option is Disabled. Once done, you should be able to ping the WAN side from outside of the network.

New Member

Re: RV016 Small Business Router Does not Answer to Incoming Ping

Hi Rocater,

Can we enable the ICMP to only specific IP addresses only?

Thanks.

Silver

Re: RV016 Small Business Router Does not Answer to Incoming Ping

hi,

No we don't have that much control over ICMP replies. Its either all or nothing.

Jasbryan

1404
Views
0
Helpful
3
Replies
CreatePlease to create content