I purchased a RV042 V03 router with firmware version 4.1.1.01-sp (Dec 6 2011 20:03:18) and I need to create a VPN connection through a remote client. I added a new tunnel in the "Client to Gateway" section, so I created a VPN client access, but connecting remotely by the QuickVPN Client after the connection and testing of the network I get the error "the remote gateway is not respondig, do you want to wait?" and I'm not able to establish a connection to the network.
If someone can give me assistance, I can provide remote access directly to the router and the IP address to connect remotely.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...