I purchased a RV042 V03 router with firmware version 4.1.1.01-sp (Dec 6 2011 20:03:18) and I need to create a VPN connection through a remote client. I added a new tunnel in the "Client to Gateway" section, so I created a VPN client access, but connecting remotely by the QuickVPN Client after the connection and testing of the network I get the error "the remote gateway is not respondig, do you want to wait?" and I'm not able to establish a connection to the network.
If someone can give me assistance, I can provide remote access directly to the router and the IP address to connect remotely.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...