I seem not to be abled to connect my iphone to RV042 VPN router. VPN is working cuz im abled to connect through QuickVPN client on external computer. Sadly i dont know how to use the client certificate (exported from the RV042) on my iphone (it does not support the .pem format). When setting up a Client to Gateway tunnel with a preshared key and setting up the Cisco VPN client in the iphone accordingly things goes wrong. Connection is accepted but stalls with log message:
(NATT) Initial Main Mode message received on xx.xxx.xx.xx:500 but no connection has been authorized. Check your tunnel endpoint (gateway) setting.
If somebody has an iphone IPsec VPN working on this kind of router please let me know. I really wanna ask you some questions on how to set this up.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...