I have a RV042 with a pair of Cellular modems. They are connected, and managed with the "Smart Link Backup". The RV042 must also maintain a VPN to the home office. It has been in the field for about a month now. My 2 issues with this are:
1> not very easy to tell which WAN is active. Going thru the logs is no answer. This info should be displayed on the System Summary, not something which needs to be searched out in the logs.
2> the device is not "failing back". It fails over just fine. but, when the Primary is back online, it never returns. I suspect this has to do with the VPN and the "[ ] Tunnel Backup". My workaround for this has been to connect during "off hours", and just reboot the device.
1> Under Dual Wan>>> Smart Link Backup, which wan is set to Primary? This wan will take care of the traffic until it fails.
2>Under Network Detection Services the default Retry count is 5 pings and the Retry timeout is 30 seconds wait for the next ping. For testing purposes change this settings to retry count of 10 pings and retry timeout of 15 seconds. This will allow for more pings in a less interval time to detect traffic.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...