I established a VPN between 2 RV042 (from point A to point B). I want to direct all traffic, including internet browsing exclusivly thru only one of the RV042's (ie everybody at point B has to access the network at Point A, and also browse the internet thru Point A) . I can access the local network (at Point A) without a problem, but can not reach the internet, since there is I believe no DNS resolution. Is there a way to do this? What would be the proper configuration?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...