01-03-2012 01:46 PM
I have a RV042 and I want to tell it to allow certain IPs to use WAN1 and others to use WAN2. How do I do this?
01-05-2012 09:03 AM
Use Access Rules to block the use of either of the two WANs for the specified IP range... That should work. Monitoring it would be a different story, but in theory...
01-05-2012 09:19 AM
Kim,
What you want to do is to set up protocol binding- you can specify inside address to use a given wan address. Under the system management tab - dual wan is enabled (load balancing) then down toward the bottom will be protocol binding section. If this is a version 3 router you will need to click on wan tabs and edit to configure protocol binding near the bottom of dual wan page.
Hope this helps,
Jasbryan
01-05-2012 09:23 AM
Can you elaborate for us on the reason binding is prefrred to "Deny" Access Rule for the range to a WAN port?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: