I have a RV042 v.220.127.116.11-tm in the office and we upgraded our bandwidth to 80mbps, however it's only testing close to 20 at best. When I plug it in directly to modem and run the test we're getting close to 90mbps. I've even tested off during closing hours and still the same 10-20mbps. I read that the RV042 is capable of handling 80mbps and even on a busy day we don't use so much bandwidth.
Is there anything I should look at to adjust the bandwidth?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...