Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RV042 not sending ProxyID to juniper

I have a RV042 created a gateway-gateway vpn.  I can negotiate phase 1 and when I get to phase 2.  It fails with the following error.

Rejected an IKE packet on ethernet0/8 from ... because The peer did not send a proxy ID.

I'm way over my head on this, so any help would be appreciated.

Thanks In Advance.

4 REPLIES
Bronze

RV042 not sending ProxyID to juniper

Hello Joe,

Thanks for posting in Support Forums. Try disabling NAT-Transversal. Let me know if it didn't work.

Thanks,

Vijay

New Member

RV042 not sending ProxyID to juniper

Thanks for the response, I have disabled NAT-Transerversal in "advanced options" in the VPN setup.  Still same error. 

New Member

RV042 not sending ProxyID to juniper

Any one?

New Member

RV042 not sending ProxyID to juniper

Hello Joe:

Please refer this article for the creation of the Gateway to gateway tunnel.

Configure Remote Gateway VPN tunnel with a Static IP Address on RV016, RV042, RV042G, and RV082 VPN Routers

Remember that the configuration must be the same in the the 2 points.

I hope this help you.

366
Views
0
Helpful
4
Replies
CreatePlease to create content