I am using RV042 router with firmware 220.127.116.11-tm.
I have two live IP address which I'd to assign to a two PCs on my LAN. When I setup one-to-one NAT the two machines become accessible from the internet. However no outbound traffic then works for those two machines; i.e. I cannot access anything on internet from them. As soon as I disable One-to-One NAT outbounds starts working perfectly.
I have tried changing the default Access Rules but all in vain.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...