Hello, we have in our company Dual WAN router RV042 with NAT 1:N and on LAN we have VoIP PBX WELL mPBX-100. It was working for about 3 weeks, but yesterday I was upgrade firmware from 4.0.0.07 to 4.0.4.02 and after upgrade don't work VoIP PBX. SIP trunk on VoIP PBX go to status Failed after about 30 min and I must reboot router for re-registering SIP account. I think in the new firmware don't work port trigering or something similar. Old firmware 4.0.0.07 don't possible download from cisco web pages. Thank you for help.
Re: RV042 problem with VoIP after firmware upgrade
I did try downgrade to version 4.0.0.07 by flash utility, but software write something like "TFTP server not running". Next I did try restore factory default settings and new device setup, but problem still exist. Now I was change Load balance mode from "Auto mode" to "Smart link backup" and now it works, but this is only temporarily solution. I want to servers and PBX will connect to internet via WAN1 and workstations and laptops will connect to internet via WAN2, only when one line is down connection will route via second line. In firmware 4.0.0.07 it was working well. Please help.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...