Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

RV042 remote traffic


I have subscribe a telecom MPLS VPN circuit between main office and Branch B, see attached (sorry I don't have better tools to draw the net diagram)

Branch B do not have internet connection, I want to bring all internet traffic EXCEPT e-mail and some local service to the main office internet gateway.

The telecom guy told me i need to do the many-to-one NAT and static route in my own RV042.

They have install two Cisco router in both end ( and

I found in my RV042 (latest firmware only have one-to-one NAT, that isn't allow me to setup the 192.168.2.x traffic to map a real ip.

My ISP in main office offer me 16 addresses that i can share it to the NAT.

So could you suggest me how to setup the NAT and static route page?

My objective is want to bring ALL internet traffic from Branch B (192.168.2.x/24) to the main office gateway (, except local service.

thanks in advance !!!

Everyone's tags (1)

Re: RV042 remote traffic

Does this appllication note help?

New Member

Re: RV042 remote traffic

thx Steve, this note is useful for both side use RVs family but not applicable to my scenario.

my network is only one side using RV042, still looking for NAT solution for my remote office traffic.

thank you!!

CreatePlease to create content