I'm about to replace the router that my ISP provides with something that is more reliable and that lets through SIP (VoIP phone).
My ISP provides internet (VLAN 102) and IP-Television (VLAN 101). I need to have 2 seperate LAN's on the inside that is potected from each other. My plan was to use a RV082 but I found out it does not support tagged VLAN.
So will one SLM2008 and one RV042 do the job or is there an easier way to do it with just one box?
My planned setup:
One port to ISP's fibre media converter (VLAN 102 and VLAN 101 tagged)
3 ports for television (VLAN 101 untagged) connected to Motorola settop boxes
1 port for internet (VLAN 100 untagged) connected to RV042 WAN port
The 4 LAN ports on the RV042 can be set to seperate VLAN's. The 4 ports will be on the same subnet and share the same DHCP pool but traffic on one port cannot be seen by a device connected to an oher port. And devices connected to one LAN port cannot communicate with devices on one of the other LAN ports.
Have I understood this last bit correctly? Others have successfully used SLM2008 with my ISP so this part will work if I manage to set it up correctly.
This forum primarily deals with Cisco Enterprise switches so much of the knowledge is about those which may explain why your'e question hasn't be answered. The SLM2008 is a small business switch and they have their own forums on CSC. No offence is intended, it's just that if you move this post to that forum you should get an answer to your question -
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...