Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RV042 static NAT

Hi,

I'm using the RV042 router for using NAT.

but, I could not find to configure " Static Nat" in RV042.

For configuration ,It only support to based Web. right?

I know Cisco Router(C2811..etc) is able to support "STATIC NAT in console.

168.126.62.x  101  >  192.168.x.x   40001

168.126.62.x  102  >  192.168.x.x   40002

168.126.62.x  103  >  192.168.x.x   40003

Please let me know if you have any information that.

Thanks.

1 REPLY
Cisco Employee

Re: RV042 static NAT

Under "Setup" there is a "One-to-One NAT"  where you can map external IP addresses on the WAN port to specific internal addresses.  You are required to have multiple IP address.  You can also do port forwarding where you forward traffic from the WAN to a specific internal IP address based on incoming destination port.

2238
Views
0
Helpful
1
Replies