RV042 V3 and Configuration Files

[fmarshall]

I'm wanting to configure a number of RV042 V3s to firmware 4.2.3.08.

I have configuration files saved for these - having been created with earlier firmware.

When I load the configuration, it seems that the RV042 (with the 4.2.3.08 firmware installed) goes back to factory default settings.

This is rather inconvenient as then one has to re-create the configuration manually.

I suppose I could load the firmware on a production system first; then back up the configuration; then apply the configuration to another 4.2.3.08 device.  But that creates its own challenges..

[Ami Xiao]

I think it might be cause by the database fields were different, you should try to load configuration on previous firmware the upgrade to 4.2.3.08.